1974Monstee
Member
I have a 1974 Duster what is the best way to remove all the undercoating so I can POR the underside?
Thank you
Thank you
small torch,putty knife,and a wire brush.
High powered pressure washer does the same thing but doesn't remove the factory paint.
Running hot water? Running really hot water.
Instead of a small torch I used a cheap heat gun from Harbor Freight. It only cost about $8. Then as said before a scraper, wire brush, straight edge razor scraper and some sort of solvent to clean the residue off.
BTW - you only need to use POR-15 if there is actually rust present. It does basically nothing on clean/rust free metal.
This stuff works really well at stripping paint and undercoating. Just don't get it on your skin. I wear rubber gloves for handling chemicals and a face shield.
This stuff works really well at stripping paint and undercoating. Just don't get it on your skin. I wear rubber gloves for handling chemicals and a face shield.
I have a 1974 Duster what is the best way to remove all the undercoating so I can POR the underside?
Thank you