what gauge sheet metal?

[7dart0]

i have a small hole on my floor board about the size of a quarter and also nee some rear quarter work. what is the sheet metal gauge for both of these.

tom

 

[Corrupt_Reverend]

I threw a sheet gauge on my '72 Dart's front fender last week before starting the shave job on the side markers and measured around 18ga. For what it's worth, I made my patch panels from 20ga and they seem alright.

Not sure if that info will help ya, but I figured I'd post it just in case.

 

[Dodge33]

I believe original is supposed to be 19 gauge........ but as the
previous poster said, 18, 19, 20 gauge will work. Good luck on your
project.

 

[7dart0]

kewl thanks for the replies.