Which driveshaft?!

[vntned]

So I'm in the middle of some upgrades on my '64 Dart, and need some help. So far I've replaced the stock 7.25" rear with a fresh rebuilt Abody 8.25". Next, I'm about to pull the stock 3spd gearbox for an A/F body A833 overdrive unit.

My question is, what stock driveshaft do I need to fit with out any modifications? My old driveshaft is to long, and is a ball and trunion setup.

Thanks!

 

[leblanc]

If you are have a /6 now and keeping it, and if the standard tranny fits then I think that your best bet might to have your shaft cut to fit, but make sure any measurements are made only once the standard trans is put in, for the simple reason that the standard might be shorter than the automatic and therefore might end up not being too long. Good luck with your upgrades.

 

[vntned]

No automatic here. I'm pulling the A903 manual, non synchro 3spd trans in favor of a 4spd.