[Found!] WTB: Blower motor switch and harness for '67 Barracuda
- Thread starter Capecodcuda
- Start date
-
- Status
Super-Cuda
MOPAR .. Move Over, Plymouth Approaching Rapidly!
Hey Capecodcuda,
Do you still have the original switch ??
If so, you may be able to refurb it.
Lift the two tabs holding the switch plate to the housing.
Inside you will see the switch rocker assembly.
Its probably full of 50 plus year old hardened grease which causes the problem.
Get some electric contact cleaner and flush the internals thoroughly.
Apply some dielectric grease , put the switch base back in place and fold the securing tabs back down.
This worked great for me and saved me from paying an exorbitant price (close to 200.00!! ) for a new one.
Hope this helps.
Cheers!!
Do you still have the original switch ??
If so, you may be able to refurb it.
Lift the two tabs holding the switch plate to the housing.
Inside you will see the switch rocker assembly.
Its probably full of 50 plus year old hardened grease which causes the problem.
Get some electric contact cleaner and flush the internals thoroughly.
Apply some dielectric grease , put the switch base back in place and fold the securing tabs back down.
This worked great for me and saved me from paying an exorbitant price (close to 200.00!! ) for a new one.
Hope this helps.
Cheers!!
Thanks for the input. Unfortunately, I don't have a proper original switch; the one I have is the wrong style for a '67 so I'm trying to correct that. I'll make note of your comments for future needs- thanks again!
grampscamp
Well-Known Member
I should have that. I think 67 is a one year only switch.
grampscamp
Well-Known Member
Found the switch. I'll see if I have wiring tomorrow.
- Status
-
