Recent content by Cameron1038

Whew.. thanks guys.

Why doesnt it cover the water jackets?

Is there any reason i shouldnt use it without a/c?

they did all come off of this motor, but im not sure if it had a/c or smog pump. ..it was a 67 so i dont think it had a smog pump.

Hello, I was hopin you guys can verify that ive got the right parts before i clean them up and go together with them. These are hipefully the right: Crank pulley, pic 1 Balancer and crank pulley pic 2 Fan pic 3 Water pump/fan pulley pic 4 Thanks Cameron

Thanks autoxcuda, this is great info.

I probably could.. i would need to put longer studs in my rotors, but the wheels would stick out a little further than i want them to.

Also.. will the 225 55 16 that i have fit on an 8" wheel.. its only .5" smaller than what theyre on now.. ?

Yeah, the 17" mustang wheels might be a different story, also i think ride height would play into it also.. i.e. what angle your uca is sitting at and therefore how close to the wheel you are. Yeeah.. i dont need my hand held, i effed up, i didnt check fabo first like i probably should have...

Yeah i thought about the harbor freight dollys but i think my dad wants it off the slab ( hes not into cars). Also thought about wheel spacers. Will need to put some longer wheel studs in, but for the time being, i think thats all i can do.

Is necessary. Dont buy these wheels for your swinger with this set up, they wont fit!

Hey folks, I made an error in wheel selection that i guess i should have seen coming. Heres my story. I rebuilt my front end in my 73 swinger and did a disk brake swap at the same time (bfj body spindles). I didnt have any wheels with the big bolt pattern or much cash layin around so i decided...

Thanks! The bottom one is what came out of my car. Went out and looked at my old trans and found that braket i need.

Hello! One of these crossmembers came out of my 73 swinger /6 904 car, the other came out of a 73+ v8 swinger in a junk yard. Im putting a 318 and 727 in my car. Went to the local parts shop to get a new trans mount.. they gave me a funny looking round bushing that i dont understand :/...

Do you still have it? I just busted mine :(