Recent content by cgfen

google drive link should work now. If not LMK.

We’ve owned this car for nearly 6 years (time flies). It’s my wife’s car and she says it’s time to sell. Located in Vista CA, near San Diego. Asking $35K OBO I’ve owned 9 A body Barracudas over the past 40 years, though with an admitted 30+ year gap, so we had a clear vision regarding what we...

hmmmmmmmm, not such an old thread at all :-)

old thread, i know our 69 'Cuda 383 S, has power steering and brakes from factory. Of course its a FB, not notch if that makes a difference?? (same engine compartment space).

Not sure if this is the right forum, but fuel systems didn't feel right either. We have a mostly original 383 S. The pie plate is as shown below 383 Four Barrel I recently saw an issue of Graveyard Cars where they worked their magic on a similar 383 Cuda, but that pie plate said Super...

The answer is......................... 8-32 phillips head machine screws. the smaller the head, the easier it is to align the fastener with the "j nut". the short one is ~ 1.5" the long one is ~ 2.25" YMMV depending on part alignment.

old thread but i just did this. I "splinted" with strips of thin metal, then JB welded as required. Don't forget to sand down the excess.

from a /6?? slant six? Thanks be well.

and that's the reason I didn't stress about getting a perfect pattern, still likely did too through a job as compared with factory.

Sorry. I don't have much to offer. We bought the car in ~ 2016 from a guy who was the master of half-a$$ed repairs, but don't get me started.............. maybe I'll post what I found on one area of the car in the thread I started a while back about refurbishing grills / grilles. When we took...

so sad, no replies. I'm searching for the same info. Will post once I sort it out

Good conversation here. I'll add more once I paint.

You have a sharp eye. I installed the "wrong" fitting because I had the wrong replacement easily at hand. I now have the correct fitting, and will re-install. Be well.

Good looking car. No I meant, green exterior with white stripe and white interior. Be well.

Thank you. I think I can handle the messy overspray look................ :-)