Recent content by DARTDALE

  1. D

    what is section on 28/12.5/15 on 12 inch rim?

    Thanks yall! Thats exactly what I needed to know!! I can order me some TARs now. Stinking things went up $10 a tire at the beginning of Feb. Reckon I should have ordered them in January. Oh well they will last a long time since I dont drive the Dart much. Again thanks!!
  2. D

    what is section on 28/12.5/15 on 12 inch rim?

    No Not a trick question. I really need to know? The section isnt always what one might think it would be or reported to be by a manufacture. I know from experience.Most folks seem to be using a 10 inch rim and thats what rim is used when given specs.on a mfgs or retailer web site. I have a 12...
  3. D

    what is section on 28/12.5/15 on 12 inch rim?

    Any of you guys or gals running a 28/12.5/15 street Radial on a 12 inch rim? I am looking at some MT S/R 28s and need to know the section on a 12 inch wheel.
  4. D

    tire recommended for 10 inch on a 12 inch

    For a 72 dart street car.I have 325/50//15 under there now and they are just to close to outer fender and inner rail.I found some MTs that are a little narrower and the same height. The 12 inch rim allows the 325s to bulge out further than on the typical 10 inch rim.
  5. D

    tire recommended for 10 inch on a 12 inch

    Have any of you guys installed a tire recommended for a 10 inch rim onto a 12 inch rim?
  6. D

    Chrome ecu in place of a orange one

    Thanks for the fast response!!!!!
  7. D

    Chrome ecu in place of a orange one

    Is it ok to use a chrome 4 pin in place of an orange 4 pin ecu? orange one will no longer start the car,no spark. Used chrome one will. Just dont want to mess anything up.
  8. D

    Oil pressure sending unit question

    Not sure on the voltage,but am going to find a different power source. Thanks fishy68
  9. D

    Oil pressure sending unit question

    If a person doesnt have a full 12 volts going to an electronic oil pressure sending unit, will the pressure readings be off a little or a lot? Or does it make any difference if the voltage is a little low?
  10. D

    Sound deadner & heat barrier?

    What are yall using in regards to sound deadner ?
  11. D

    Oil pressure Guage Electrical ? Or mechanical?

    What type of oil pressure guage is better? are you using? Electrical? or Mechanical? I have an electrical at present but not real sure of its accuracy.I am thinking of going mechanical? Not sure though if its worth the effort.
  12. D

    Column shift with headers?

    I used Dougs on my 72 Dart and colum shift. Tight fit but no problems.
  13. D

    freshley rebuilt 727 not shifting to 3rd

    Actually , I will have to drive it again to find out. but if I recall correctly it seems to be about 25 to 30 mph or so when it goes from first to second.
Back
Top