Recent content by macho781988

its an 86 monte with a 305 and od trans, now i know its a chevy but the universal floor shifters are all the same and i know i can trust wat you guys say since many of you do this swap for drag racing. let the hatemail commence! lol

well, its not a mopar that im putting one in so i think itll be cheap. so would it still br pricey to put a stocker in? also i dont want a rachet shifter or racing style as its just a driver and the floor shifter would just make it better to me.

i bought a car recently, and id like to buy a floor shifter for it and wanted to know how hard itd be to install and run or if there are any issues i should worry about? and for you guys that have the floor shifters how do you like them? also do i really need a b&m or should i just find a...

does anyone have a diagram for where the vaccum hoses go on this carb

the part numbers sum-900156

the carbs a holley 2bbl, but im also 26 and this isnt my first toy and wont be my last so im always looking for multi taskers and such when i buy tools, i do have a flaring tool, and i did order the summit tubing bender and i talked to the tech and all that but if im not happy with it ill return...

right on, ill be sure to do that

i did used to drive it alot, but last feb when i started at oriellys and i ordered the fuel cell for the swap it still ran good, but in the middle of summer it developed a miss, now i sent it off to be cleaned and the miss kinda went away, and after the fuel got in, the manifolds got back on its...

the same, i turned the dizzy and it runs alot better, my exhaust issue will also be fixed when i get a plug for the egr on the manifold, but hey i checked for vaccum leaks and found none, so after i plug the manifold, and adjust the idle then i can take it to a shop where a buddy of mine works...

ok ive discovered my exhaust noise, theres a cap plug missing from the back of the exhaust manifold

i need 5/16, thats the issue most are meant for small brake lines, i need fuel lines

im gonna try the ones from summit paid 50 bucks, ill let you all know how they work.

ive checked out the east wood ones, and even ones from snap on, i just do want them breaking, and ive read reviews that they wont bend 180 degrees so idk. i still have the pump to filter metal line, i need the one from the carb to filter cause its a rubber hose atm and i know thats not right

do you have a website or part number? or is it just the ones off summit made by titan?

trying to make a carb to pump metal line but my current bender just wont cut it. ive seen the 2 lever ones and id like to have one like that but are they worth it or should i try a new approach?