Recent content by moparduster

Went from Hoosier 28X10-15 to Mickey Thompson 28x10.5-15. Actually had more space between the tires and the springs. Running 3/4 shackles. I know it looks close but they have never touched. Sorry the tire pic looks like crap. Just walked out in the rain to take it.

Nevermind found it on FABO 2 mins after posted.

Searched google but can't find it. Need the size for the 3 screws that hold the filter to the valve body of a 727 with shallow pan. Lost the old screws and installing transmission today.

Does anyone make a bracket to put the alternator on the driver side of a small block. It's going into a 71 race car and would like to run a short wire to the +side starter post. Is it possible to use the factory brackets and turn them around so it work on the driver side?

Dont know if im in right section with this question, but does anyone know what size the front wheel studs are for a 71 Duster with drum brakes? Need to change out the wheel studs and dont know the size.

Do you know if there is a link or a write-up about putting one in the k-frame?

Has anyone installed a manual rack and pinion into an A-body. I have fab skills and know that it wont be a "bolt-in" But just trying to get ideas how you mounted it. brand, size, u-joint lengths. Adapters. Any info would help and pics would make wonders. Thanks

It has accel pumps but not sure about the power valves. It does have a boost reference port on the side of the main body. Not sure if i can cap that off or what all I would have to do. I know I should just buy the correct one but honestly dont have the money for that.

I have a new 750 cfm supercharger carb and wondering what mods need to be done to make it work on a n/a engine.

If your talking about a 6.1 from Mopar, they do not come with a tensioner.

The Dayco has better tension vs the rest. When my company (High Horse Performance) installs superchargers on the SRT cars we only use Dayco tensioners because we have seen the factory, ACdelco, off brands, etc. literally explode. Unless your going the supercharger route you dont "need" it but we...

Still available.

Does someone have a like to a how to remove and install lca and torsion bar on a 71 duster?

Would perfer a 741 or 489 case. Not concered about what diff is in it cause im going to put a spool in.

Looking for a 8.75 center section from someone in the charleston, sc area.