Recent content by MOrePowAR

Dahinda, IL 61428

I have a bench seat from a 72 Dart it needs to be redone, springs are all good, tracks and frame are fine. Pick up only too hard to ship

I got a bell housing flywheel pressure plate, disk, throw out bearing with armall for a slant 6

I have 5 off the same car a 72 Dart

Made my own connections plates to 3 inch, no mufflers, used steel wool at the end of the pipe and capped it with baffle steel

I used their product and had no issues something is wrong, is the mount notched enough

If you want the hole for the scoop to be over the air cleaner measure from fender to fender and cowl to center stud on air cleaner most engines are off set to the passenger side

My son made mine out of mirror plastic

It's not all info-commercials like all the rest of the shows. Give me all the free **** these shows get and I'll build a nice car.

I'm 40 miles out of Iowa. Gravel is the worst to have it's always letting moister up from the ground. Metal buildings are great if there insulated. My building is 45 X 40 12in walls and 18in insulated ceiling, has hot water heat in the floors, concrete poured over plastic then 2in pink board...

got any pics

Did you try Kantors?

When I put the 383 in my 72 I had the same issue. From the looks it's rubbing, somewhere I read about this problem and how to solve it. The fix was heat the corner of the oil pan take a flat body hammer and a second hammer and tap in the corner of the pan DON"T use a torch just the small propane...

Got lights and arm rest Tks

Scarebird makes a disk conversion for the 67-72 A-bodies using a 14 in wheel