Recent content by Robco1

Did Ron Francis help you out on hooking up the wiper motor switch?

I too will be replacing tank, pad, everything up through fuel pump and want to go with AN lines / fittings. My question is do I run the ground from the sending unit to the frame instead of to the an line (I know - stupid question...). Thanks.

Mine is a Wizard Cooling rad with 4-Spal 9" fans in a 67 Barracuda with a 383 big block. Not a lot of room. Mike

Never mind:) I found a previous thread on Defroster Hoses (tubes) and they recommended Nostalgic Air Parts. I checked them out and ordered enough hose for two sets for under $20 with free shipping. Thanks.

I have a 67 Barracuda whith two front defroster hoses that are falling apart. The driver's side inlet is 2-1/4" in diameter and the outlet (attaches to defroster vent) is 2-1/2" in diameter. The passenger's side inlet is 2" and outlet is 2-1/2" in diameter. Does anyone know where i can...

Okay, I will give it a try. Thanks.

I am trying to remove the wiper motor from my 67 Barracuda and the thing will not budge. I have removed the wiper arm linkage and bolt from the motor shaft, and the three nuts holding the motor to the firewall. Is it the seals / gaskets that is keeping it on? The engine is installed so I...

Thanks toolmanmike, it was quite the project!

That is actually what I bought, cut to fit and put it on. After filling the rad, I immediatly began taking the hoses off as they were leaking. I couldn't tell when it was tight as there was never any resistance, so I overtightened them and split them. After that I purchased a product...

I picked up a rad from Wizard Cooling; aluminum with shroud and four 9" Spal electric fans. The rad is OEM size and mounting (close anyway), you can specify inlet / outlet locations and sizes. I had similar issue of clearance to water pump pulley. I have about 3/4" to spare with this setup.

I'm running Valvoline VR1, 20-50. O Reillys carries it as well.

Looks awsome. The rad looks like a BeCool product? If so, how did it fit between the frame rails? I looked at one but it looked like it would be tight, especially with the fans fitting in from of the pulleys. How much clearance do you have?

That worked! There are four little indentations on the ring, I almost didn't notice them. Thanks.

Thanks, I will give that a try.

Are you talking about the trim ring bezel?