I'm thinking it's either the ignition switch or the fuseable link that runs to the coil from the ignition. Everything else checks out as far as voltage goes.
Ok I'm having starting issues. I only have 8.5 volts at the coil. Not enough to start the car. If I run a jumper from a good 12 volt source to the coil car starts with no problem. Details include the following; MSD coil, MSD ready to run distributor. No MSD box. Any ideas on where to start?
I think I'm going to create a template from a piece of cardboard. I tried dabbing a little paint on each of the studs (14) and holding the panel in place. Wasn't able to align it without trouble.
I'm looking for some advice on installing a GTS tail panel on a 270 decklid. Does anyone have a template? Lots of holes to drill and want to do it right from start.