Very nice job! I just finished installing a set of long TTI headers in a 72 Dart. Absolutely by far the worst pain in the @#$&* to install. Basically had to pull the engine out and angle it towards the drivers side then the pax side to install. It was horrible. Anyways they are installed...
I would probably pull engine and pan to investigate the issue if that’s possible after ruling out a lifter problem. Not what you want to hear I’m sure. Could be an oil pump giving out. I’ve had that happen.
I did some more research and called the company that built the transmission and they said it didn’t matter. That is if both hook ups were at the bottom of the radiator. So you were right it didn’t matter.
Hello everyone. This is a crazy question but I have a 72 Dart that I’m restoring and forgot where the transmission lines go to the radiator. It’s a 727 torque flight. They are braided so they look the same. I forgot to mark them. Any help would be appreciated. Thanks
Good morning. I was wondering if you could tell me exactly how you wired the power wire to the distributor. Maybe a pic or 2. I have the same set up but but can’t find a lot of info on wiring. Everyone says just take the two wires off of ballast resistor and put them together the pigtail to...