Hi folks. i am picking up a 72 4 door carts car> has a really nice floor and trunk. Anyway the trunkpan and inner 1/4's will work on a 74 2 door? Inner Wheel wells?
Lol I just realized that my timing is 8 degrees after tdc, I think I better change that first lol
Talk about a retarded move!
I'll check the secondaries manually to see if they are stuck or blocked.
Since some has mentioned that a 318 won't pull enough air to open the secondaries, would it be...
Hi folks,
My drivers side sit a lot lower than the passenger side. Can I turn the bolts that sit in the lower control arm and pivot on the torsion bar?
My plan is to max lift both sides and then lower to make sure both sides are equal.
Turning which way lowers or lifts?
Ended up using the 2 bbl throttle parts just one cut and weld a piece in to make it taller.
So she's in and running. Got to tune it and give it a test run..... Been raining here all weekend :(
Ok I think I got the lines ok. I found a diagram I online.
Now I am getting some flame through the carb. I had to move my distributer to get my old manifold off. I was 95% sure I put it back in the same place but now she won't fire?? I have lossened it back up to try advance/retard but still no...
I don't know the 550's model number of hand but I know it was running on top of a 360 with a torker 2 so I know it will run.
My 2 bbl is in the motor now and could use a rebuild so I figure now is the time to change it over to 4bbl (damn ethanol)
The offy has a dual plane already and the...
Of course a performer rpm would yield better results but the offy is sitting on a shelf in my garage. I like cheap power lol
Should I throw a carb spacer on too?
Will I be + or - for top rpm with this change?
It's just on a 318 stock (74) with headers.
I will be running a Holley 550cfm on top of the offy
And yes I know the dual port is a very bottom end intake
I had a old chevy 4x4 I did it to.... inside and out!
Pros.... never rusted, resisted dents, excellent when I went in deep water
Cons..... Heavy, ugly, not comfortable to lean on,
Has anyone mounted hi beam lights behind their grill? Maybe mounted on the rad support.
Anyone got pics?
I have a set of hi intensity 6054's lying around and I was thinking that if I hid them behind the grill they would greatly help over the old school yellowish beams