Search results for query: *

Have a dry newly build 904 Trans , dip stick miss placed along the way. First Q, are 904 and 727 dipstick the same length? Second Q, I bought a cheap fender mount braided 904 dipstick hits bottom of the pan with about an inch to long , has Allan bolt to cut cable and adj in handle. How...

So I assembled my rear end yesterday 8 3/4 3:55 green bearings! When I bolted down my axles and backing plates things got a little snug! Axles have 3" studs, bolts with lock washers under heads. Pass side clears with less then quarter inch from spreader bar for shoes, driver side hits spreader...

So I have purchased a used and not quite assembled 489 c\section with clutch style suregrip. Pinion bearing not all the way on and ring gear turns not so freely! So I have installed new pinion bearings and have reassembled unit, it seems when I tighten side bearing caps they pinch outter races...

Ok so my questions are... Running 904 behind fresh .60 over 360 and after a couple of weeks of sawing off a tire or two ,second gear started to fade away. This did not surprise me to much. Forgot to mention a new 2800 stall converter as well. The trans is dated 69 don't think it has been cracked...

So I recently built up a decent 360 .60 over est. h/p 375 ish( shoulda went bigger cam!) anyways did not take long before 2nd gear faded out on me! Have a new 2800 stall converter. So back to the point, I am planning to rebuild on my own although the more I read, the more intimidating it seems...

The easiest way to visually identify the difference? Pics?

Looking for parts breakdown column and auto center console linkage to 904 trans. First time swap need to dbbl check to make sure i have what i need!! (linkage) '69 era

So I've got a question about 8 3/4 rear end. What is the difference between 742 c section and a 489 c section, other than the pinion diam. I have a 489 that I was going to use, and have the opportunity to buy the742 which I will. I was also at the local drags this week end (Thunder in the...

Just have a quick question I'm getting rid of a motor and trans / 6 and I'm assuming it has a 904 backing it up but I'm not sure # 3743421 x 549 2595 If anyone could help that would be great. Also I'm having a hard time finding a good web site for looking up old part #'s thanks