Search results for query: *

A friend of a friend might be taking it. If that falls through, I’ll get in touch with people in the order they responded. Thanks

273 engine from '65 Belvedere. Turns over, bores look reasonable. Partially dismantled but appears to be complete. Has adjustable rockers. Heads look like they may have been rebuilt but have surface. If you can use and can pick it up from Fullerton Ca you can have it free. I have an engine hoist...

Thanks!

Nice, if you do pick it back up please post tire sizes. Thanks

Cool, thanks!

Thanks for the warning :thumbsup:

Thanks!

Thanks guys. Are '67-69 A body the only tracks that will work? I see the floor reinforcements fit through '76 - are the pans the same?

Besides seats and tracks is anything else needed to swap from a bench seat to factory buckets on a '68 Barracuda?

That looks great What size tires and wheels?

I’d go with at least a 165/80x13 to get a bit more height to fill the wheelwells

Thanks guys!

Getting a '74 Dart sport running after it’s been sitting for a long time. It’s a console shift car but some of the linkage is missing. What exactly do I need to connect the shifter to the trans? I'm guessing there should be a bracket that attaches to the trans and a link going forward to the...

Wanted - hood for 1974 Dodge Dart. Prefer SoCal area if possible. PM or text/call 714 482 7175 1973 1974 1975 1976

Thanks, yeah it’s definitely obvious who actually read the original post!

Thanks for all the responses - I found the problem - the gasket between the pump and block was incorrect and blocked off one of the oil passageways. I’ve got 55psi with the drill so it’s good to go.

I’ve run the drill for at least 2 minutes multiple times, surely that’s enough?

25w/50 and between 55-75 degrees depending on the time of day I’ve been working on it

Yeah, turning the pump counterclockwise

It’s a new pickup. Drill doesn’t bog at all.

Already done that - I swapped to a different known good pump that just had a coating of engine oil put on the rotors and housing.

This driving me nuts! Swapping in a 440 motor home motor. Had to change the pan and pick up to car style ones, used a factory pan and factory style pickup which is right on the floor of the pan. Put new gaskets/seals in the pump while I was at it. I packed the pump with petroleum jelly to help...

I’ve pulled the side cover off, didn’t notice anything out of place although there is some surface corrosion from where moisture has got in. The countershaft rocks back and forth with the input shaft. I guess I just need to tear it down.

I've got an A833 that's been sitting for a while and I can't rotate the input shaft more than a couple of degrees in each direction. It feels like a transmission that is in two gears at a time but it is in neutral and the output shaft turns freely. Any suggestions for the likely cause before I...

Great condition set of full wheel covers for 1968 Plymouth 14” wheels. No scrapes or dents, $50 obo plus shipping or pick up in Fullerton California.

Thanks

Looking at a '68 Barracuda that had the rear floors cut out for a tub job that was never finished. Would the floorpans/inner fenders/trunk floor from a Dart or Valiant be the same so I could put it back to stock?

Finally got the adaptors from my buddy so ready to trade. PM sent to 66fs

Haven't been able to get the large pin ones from my buddy yet. Will hopefully get them later this week. 66fs is first in line to trade but if tat doesn't work out, I'll hit you up.

Thanks, I'll keep you in mind.