Search results for query: *

I'll call their stuff junk!!! Arms are sitting in my garage for anyone to look at.I just shake my head every time i look at them.They could have hurt or killed me,my family or anyone unlucky enough to be around at failure time.

Never-taking big chance-roll the dice if you feel lucky

Be careful-i had an ucr break at weld-just my 2 cents

check out my thread from about two months ago.on page two- i feel lucky tonight.I have stockers back on and feel much better.Just my two cents!!

Ray at CAP told me they where only second pair to fail.Told me he was sorry and made no excuses.He did give me back money for arms.but i still had money in alignment and installation so i lost out because of a bad weld.At least i wasn't rolling,i guess it could have been a lot worst.I do know...

I had someone else install it,but i remember telling him 3/4 and that worked.Somewhere in a forum here is where i first read that.

Hi,Looking for a 73-76 UCA.Bushing or ball joint,Junk?That's ok. Thanks,John

I bought these arms from a well known vendor,not because they where cheap.The original arm on drivers side was rewelded when i bought car,so i figured i would go with something new.I never thought i would be putting my family or myself at risk.You would think a vendor would have a certain amount...

This happened at about 2000 RPM,getting up on the converter.If i had got moving,well i might not be writing this...Let alone the money i just tossed out the door. John

Boy you guys are good.....ESP Huh?

Just barely got back to garage tonight after a short drive.I won't say what brand or who i bought them from,till i talk to them in morning.But this is downright scary.I just had my 2 year old grandson in car last week.And by the way,they are only 1 year old and MAYBE 500 miles on them at most...

Hi,trying to find NOS outside door handle.This for a 72 Demon,but i think the actual door is 73-74.Didn't know if this matters or not. Thanks,John

Thanks for input-still learning.Thanks

Hi,just wondering what sector size means?The 1540 says 1 1/8.Does my stock pitman arm off my 72 Demon fit this? Thanks,John

it's towards the end

Yes it has the spool mounts,with hole through middle for sway bar.Have bought almost everthing new for front end and just want to get it all while it's apart. Thanks again

Hi,pretty new to all this,so sorry if sounds dumb,but can't figure this out.I believe my demon has a 73 up K frame,and i know LCA is the 67-72.So what strut rod,and what bushing is in this car.All the interchanging of parts and no known history can be confusing. Thanks,John

yes,it has disc,thanks

Hi,the 72 Demon i have,has a lower ball joint 7181FLH.I'm new and not sure if this has been swapped for 73 up or not.I can't tell if this is small joint or big one.Any help would be apppreciated.It also has the big bolt pattern if that matters. Thanks,John