Search results for query: *

Put a 440 in it! http://eugene.craigslist.org/cto/2366108372.html Wonder what type of work that took? And whether or not it's a hack job?

Hey All, Tried to start the car for the first time today after converting over to the 4-speed. I thought all I needed to do was ground the wire that went to the neutral safety switch on the old auto. Here's what's happening. 1. Without the neutral safety wire grounded, I turn the key and...

Hey Everyone, Finishing up my 4-speed conversion, and got the clutch installed, trans in, shifter in and adjusted (shifts fantastically!), and am working on the clutch adjustment. I appear to be having a problem with the clutch adjustment, and am not sure what could be wrong. When I first...

Hi All, I'm pretty close to finishing up the 4-speed swap........I got the zbar in and the bracket welded in place and all seems pretty cool. then I went to put the linkage from the pedal to the zbar on, and I can't figure it out. No matter which way I put it on, it really doesn't fit. Either it...

I'm in the midst of the 4 speed swap, and was swapping out the pedal assembly. As I was doing this, I discovered the brake pedal on the 4 speed setup was sticky, so I took the assembly apart to free up the brake pedal. When putting it all back together, I had the most irritating time putting the...

Hey All, I've started the swap from my 904 to the 833, and had a question about the drive shaft. I don't know anything about the length needed yet, but wanted to know if the one i used with the 904 will be too short to start with, or will it be long enough to make work (cut if necessary)...

Below are pics of my 67 Dart GT Buckets. I'm in the process of deciding whether I re-foam and re-cover them (I would not do this work, i would have someone else do it) or just flat out replace them with a Procar seat. If I replace them outright, what are these worth? As you can see, the plastics...

Hi All, I need to do the front brakes on the Dart. It's a 67 GT, and is still small bolt pattern drums. For cost savings and ease of finding the parts, I was considering the Scarebird disc conversion. Since this is a cost saving maneuver, I'd prefer not to have to buy new wheels to...