Search results for query: *

I'm looking for a set of these. They must be actual 79 stamped plates and must be truck plates. Prefer them in good, usable condition. Let me know what you've got!

After looking over my current fender, I'd rather replace it than re-bondo. I need this fender to be straight with no serious damage or rust holes. Would rather not use a 68 or 69 to avoid patching the unused holes. Bonus points for a GT fender so I don't need to drill the emblem holes :P...

I have a used set in great shape somewhere in the garage, if you're interested in those let me know and I will get you a picture!

I know, terrible pic, hard to tell. The wheel well portion looks good on the patch. On the upper I need it from about the middle body line down. Meaning the one that runs from the middle of the tail light.

Nice one, I hadn't seen the partials before. At half the price of a full quarter and it looks to cover everything I need, that may be the way to go. Thanks 69MOPE!

I need about the area shown in the red box. Just putting this out there to see if anybody has a nice flaw free piece available rather than buying an entire aftermarket quarter.

Yes, Summit sells gears for the 7-1/4.

I have a set that I ran on my SBP wheels: http://www.forabodiesonly.com/mopar/showthread.php?t=300873

I'm good on brake parts now but still looking for shock plates that will work with an 8-3/4 in an A Body, anybody have a reasonably priced set?

Funny you should ask, I have one. Looks like about 3 hours (I'm right next to DFW airport). Might even be able to drive a little to help you out and help me make space in the garage ;) http://www.forabodiesonly.com/mopar/showthread.php?t=301599

Will the SBP backing plates and levers work with the wider drum set up?

Need this for the 8-3/4 axle I'm building using B-body housing and 10x2.5 drums. Let me know what you have, would like a package deal if you have everything to save on shipping.

I have a small one on the 7-1/4 that's in the car now but I can always get a conversion u joint. New yokes are only $70 so I may go that route if I can't find a right priced used one.

Looking for either: 3.55 gears with matching spline yoke for a 741 case OR 29 spline yoke so I can use with a new Motive Gear ring and pinion which apparently requires the fine spline yoke for the 741.

I'm needing a pair of 15x6 or even better 15x7, or even better 15x8 wheels that will fit a 67 Dart. I'm going to swap from the 7-1/4 to a later 8-1/4, which I believe is a bit narrower and is BBP. Whenever I end up with 15x8 wheels I'll install the dr diff offset spring kit to make room. Oh...

I could use a decent rear trim panel, mine is banged up but the emblem is good. I'll look close at the rest of the trim but I think it's ok as well as the fender signals, not too bad. That dang drivers tail is busted up though, hate it looking like a jalopy! I may be over in Ft Worth tomorrow...

I think only the bumper is the same. Tails are definitely different. Why they made different tails for each year 67 68 69 I have no idea :( Turn signals are rectangle in the grill - if yours are like that please send pics! I'd be willing to pay shipping if the bumper is really nice...

I need a good front bumper - mine is all bent up. Looking for one that's straight and not pitted. Turn signal lenses - mine are cracked, looking for some that are not. Drivers tail light - need the lens (not cracked or chipped) and a good non-pitted bezel/housing would be great. Rear finish...