Search results for query: *

I am on my 3rd one. All of them very reliable and required very little maintenance too. All of mine wer 96's. this one has been with me for 3 years now, 148,000 miles and runs very strong yet.

Thanks! The engine was out of a 69 Barracuda. The lady didn't have any information on the rebuild so I am not sure what all was done. I posted a few more pics under "Mopar General Discussion"

It was a 340. And it's in my driveway... I'll post some pics later.

Thanks. I am going to see tomorrow in the morning... I am hoping it is what the guy said it is.

That sounds easy enough. Thanks.

I am going to look at a 340 Dart tomorrow and need to know what the easiest way to identify a 340 over any other engine. Is it as easy as noticing something identifiable on the block or do I need to know some ID numbers? the car is an original 340 but the engine was replaced and I wanted to...

That is kind of whay I am thinking about doing it all now instead of trying to bolt stuff on that I will be reusable down teh road. Once and done, sounds a lot easier then twice and done...

I am triyng to keep it cheaper, but after hearing all advice and options I may just spend the money now and get it rebuilt with a better cam and what not. I am waiting for someone to call me about some pricing now. If it seems reasonable I will get it done now and not worry about it later...

I am not going for a pin cushion look and I do have a small budget set aside for the Dart so I can spend some cash on better stuff. As long as it is within a reasonalbe amount. The drive shaft will need shortened anyway due to the D60 getting put in there. Motor mounts are covered with the...

I apologize for being somewhat vague. you guys know your stuff, but I guess mind reading isn't a talent you possess too... Anyway, I do just want to get it running and intend to replace the minimal for now. I can't justify spending a ton of cash on it just yet. I am using the tranny that...

I have a 360 that I got from a 78 Cordoba. So it was buried in emissions stuff. I am looking to get it into my 71 swinger with the bare minumim. Put back on it. So, where can i find some info on the parts that I can bale or keep. I was thinking about buying a new Carb and intake, Is...

I found the motor in Loveland actually... A bit of a drive for an engine, but I got to hear it run before it was pulled from the car. I found it on Craigslist. I search Denver more then the springs because the results are better. My buddy lives in Monument and has a nice buggy (rock...

Wow. Great info everyone. I have more then enough info to get started... Actually a little overhwhelmed at this point but I am quick learner. I already got some breaks headed this way so no worries there. Actually my girlfriend insisted when I told her it would be unsafe if I didn't...

65 bucks... That's 100 bucks cheaper then what I was looking at. I figured the little stuff would get me... I am slowly figuring out all that I need and plan to start shopping for parts in the next week or two.

I got the /6 out and can't seem to give it away... I got a 360 on the stand ready to be cleaned up and dropped in. I am not doing anything to the engine yet due to finances, I jsut want to get it in the car and repalce any parts that could be worn down. I will pull it in a few years and have...