Search results for query: *

This was the kit I used on my Duster. Pretty sure they make one for Darts.

What can I use to clean stains like grease and antifreeze off my tired paint job, without making it worse? Paint is pretty thin, so a little scared to buff it very much. Any tips?

I taped the area with 3M painter's tape and used a very small bit for a center pilot hole from underneath, after using a solid paint marker on the pins to mark the exact center contact point, then a 5/8" step bit from above. No cracking, just take your time.

Note it shows two other clips, for the forward most attachment points (6002 708). I have pins, but one hole in the very front on each side. I have mouldings, but need clips also. (Just saw badlilred covered that)

Beg, borrow, or buy a 73+ lock cylinder to test with.

Thinking the 73+ are a larger hole. Do you know the full history of that tailpanel? You posted before I could ask. Check specs for the later years, you might get off with just a new cylinder.

The wire might work, but if you need a strong magnet, find an old stereo speaker, the bigger the better, that you can sacrifice. I would probably just dig it out with a coat hanger. Good luck! If nothing else works use some rope or a bungee cord to hold the door shut until you have more time to...

I can get to mine by just pulling the cluster. The passenger pivot is almost in the middle. You may have to drop the column to get your cluster out though.

Dante's https://dantesparts.com/shop/mopar-catalog/body-components-mopar-catalog/mopar-body-hood-pin-kits-hood-pin-kits/

Too small at .875" Just checked my mouldings, clips should be about 1 3/4". Btw.. my car is also missing one pin. Anyone know a source for them also?

Doggy door?

Where can you get them?

Mine's not trimmed for the bulge, but the hood is cut out and my air cleaner sits above the hood in the scoop, done by a previous owner and the gap under the bulge is minimal and doesn't bother me enough to trim it until I redo my hood paint.

Bump for ya,getting ready to do a set and want to know also.

Looking for the factory measurements on the core support. As for the install- Tape off the area and use a hammer to get a witness mark? ..or is there some better way? My hood has issues already, but not trying to add more. While I'm at it,who makes a good quality kit? The...

Mine should be black,I have to admit I like the red that's on it now,but will take it back someday. I always liked this car,too.