Search results for query: *

I parted out a 1967 dart that had 1973 fenders on it. The 67 grille, headights and headlight bezels all fit well. I would give it a try. Bob

I bought a 66 Dart Convertible parts car that had a lot of extra trim items in the trunk. This set of "window" (?) trim was part of what I found. I have looked over a convertible and a 4 door sedan 66 dart and cannot find where this trim fits on the car. The guys who had the car had parted...

Painted the bumpers on my dart sport because I was too cheap to have the bumpers rechromed. Works pretty good on a race car and even gets a few compliments. All I did was wipe them off with Prep-Sol and then spray with epoxy primer, followed with a urethane 2K primer surfacer and the the Nason...

Up is as follows: Tried the 750 proform body but car suffered an unrelated driveshaft failure. After all of that was sorted out I was back to using the 650 DP holley with new u-joints, tailshaft housing, yoke, rear end flange and distributor. Anyway this weekend car went 11.98 @ 111.6 mph...

I went racing this past friday evening. Results are had to gauge, but car could be running a little bit faster. Car went 12.25 right off of the trailer and then went 12.25 (again), 12.15, 12.14, 12.15 (after I red lite) On a night when most other drivers had not picked up from the last time...

440Dart, The hood scoop is made quite well. I would buy from them again. It did not come with mounting studs or have any mounting bolt locations identified. It does have a nice 1" wide mounting flange on the inside of the scoop on three sides that allowed me to drill it, drill the hood and...

I have been racing my '73 Dart Sport 340 for the past few years using the OEM hood scoop mounted on the original hood. I have been told more than a few time the original hood should have its opening beneath the scoop enlarged to help the car breath better. Being I did not wish to cut on the...

Paint your car whatever color you like, it is your car and your opinion is what counts! If the car is modified I would not worry about using a factory color, if it has a stock looking exterior i would be more inclined to use a factory color. JMHO, Bob

I seem to remember removing one from my 73 dart sport when I took it apart (like 1996). It had 6 metal clips that went through the edge of the seal that was against the hood. I did not reinstall it since I use car as a race car, not even sure if I can find the old oone. Bob