Search results for query: *

I recently installed a Mopar Tuff wheel on my 68 Barracuda. It is a aftermarket steering wheel and a OE adapter. I noticed after the install the horn did not respond when hitting the horn button, but i figured I would get into that later. Took the car out for a test drive and the horn beeps very...

I had the new motor in the 68 Barracuda up and running last November. I had basically carried over the MegaSquirt setting from the prior slant six motor. The new motor should be 100+ HP more, has 10.3 to 1 compression, a much racier cam, fully ported head, long rods, 2.2 L pistons, but I am...

The square back Autozone Duralast alternator that was installed in September on 2016 was having a difficult time keeping up with the current demands over the past month. Especially when the ac was selected. Had the alternator tested at AZ and they agreed that it was bad. The replacement...

Would going from a 90 amp to a 120 amp nipendenso style externally regulated alternator produce more current at idle and low rpm’s? Or is the boost in amperage just at the rpm’s that produce near peak alternator output? And a second question, at what engine rpm should an alternator like those...

I am wanting to add protection to the battery cables for the rear mounted battery and also to the alternator charge wire. I think I understand the basic difference between a resettable circuit breaker and a maxi fuse in that on the CB, when tripped, one would simply re set a lever while on a...

Went through several of the flickering head light threads, a common solution is to add a relay to get solid voltage to the VR. I was ready to do that, went I went through my wiring I already have a direct line from the battery to the VR. I have a rear mounted battery with a disconnect switch...

cleaning up the wiring on the 68 Barracuda. Two questions: 1) I had eliminated the ballast resistor some time ago by a jumper across the resistor terminals. Used the existing coil wire to trigger the MSD box. In process of cleaning up the wiring. At the ballast resistor terminals is a brown...

any one using the Avital 3300 2 way car alarm? Avital 3300 2 Way LCD Alarm System I am at the point of putting the 68 Barracuda back together where the electrical system is up next. If there is another recommendation I'll look into that, but I do like the 2 way feature. here is an Amazon...

Hello, I did the Denso alternator swap using a pull a part alternator some time ago into the '68 Barracuda. Using an external mopar VR.... Currently the '68 is a drag race only car and I have it set up with a remote battery and a electrical master kill switch. The kill switch is wired with...