Search results for query: *

Where could I find some clips for the vinyl top trim on the quarter panels of a Duster/Demon?

Can someone tell me what screws are used to secure the fuel neck to the quarter panel? A pic with the cap off would be great too. TIA

I'm talking about those white foam seals that go in the door hinge pillar. The hinge bolts go through them. I would guess they are around 3/4" square. Thanks!

My Demon will be needing all new weatherstripping. Prices seem to vary greatly. Which ones fit the best? Any idea who makes the Classic Industries weatherstrip?

My '72 Demon hood stripes were removed at some point so I don't have that to go by. I'm trying to replicate the factory process. It looks like the hood was painted, then the black matte center stripe was painted on. Then the vinyl stripes along the center stripe were applied with the...

I believe most of these parts are chassis black or natural steel. Do I have these correct? Chassis black: K member torsion bars battery tray axle housing/backing plates sway bar engine mounts trans crossmember bumper brackets strut rods Natural steel: upper control arm axle bumper stop plate...

I have my hinges apart for a pin and bushing kit from Resto Rick. It looks like he paints them after they are reassembled. This would be good for me as I still need to mock up my body to check gaps, etc. But it looks like it would be hard to get them covered in paint with all the contours...

I have noticed that the center quarter panel body line is virtually straight on some cars and on others there is a slight upward curve above the wheel well. My NOS quarters have a slight curve. The AMD quarters look pretty straight in the pictures. If someone has an original paint car, I...

Need to take apart my sport mirrors, strip & paint, and re-assemble. Doesn't look like fun. Any tips would be appreciated!

Mine appear to have been dipped in a Plasti Kote type coating, then they were covered with yellow paint at some point. The rubber coating appears original but I have seen several unrestored engine bays that had nothing but body color on these tabs. What is correct?

None of my Mopars appear to have had any seam sealer on the underside of the car but there are a few places on my Demon that could really benefit from some. Do any of you guys do this?

Just curious what you guys do to rust proof your door seams. I have a door that was rust free until it sat outside full of water for 6 months. I cleaned it out but there is some surface rust inside. The seam looks fine from the outside. I think I will pour some POR15 in there and move the...

I'm ready to epoxy the underside, interior, trunk, and engine bay with DPLF. I would like to spray epoxy, then seam seal, then topcoat. There is some pitting where I blasted rust, and there are some plug welds that aren't perfect. Would a couple coats of K36 or Slick Sand before the seam...

Can someone share what color they used to duplicate the factory grey primer on the underside of their car? I am using PPG products. There is not enough left on my Demon to get a color match. Thanks

Can someone describe how the various areas of the underside where finished when it left the factory ('72 Dart)? Also, what areas should have received the rock guard or heavy undercoating? TIA!

Question on rocker panel replacement. It looks like the front of the outer rocker can removed by drilling the spot welds and dropping it down from the door post structure and the rear of the rocker needs to be drilled out and also cut lengthwise just above the boxed in area from the door...