Search results for query: *

Hey: Anyone used one of these? I got one, its got no shims and no instructions... What are you supposed to do? Just give it hell till the pinion nut stops turning? Any help appreciated. Steve

Hey All Got my replacement gears and was going to have a go at rebuilding this 8.75 sure grip unit. Anyone got instructions/torque specs? Thanks! Steve

Hey All: Anyone ever done this? Being told its a way to cheat into a slightly higher stall than stock. Just for a street car, so it doesn't need anything fancy. Thanks Steve

Hey All: Can someone tell me what I need to remove from my center section so I can run Moser Axes with the green bearings? Also, how do I get it out? thanks for any help Steve

Hey All: Long story short, is there something I'm supposed to remove from the stock center section when installing Moser 8.75 axles? Will the new axles actually fit in the housing with that installed and its really bad to have it in there, or will they just not go in at all? Thanks Steve...

Hey All Just put in my new built 904 yesterday. Its got an A&A trans brake and tons of other goodies. It clicks into each gear ok, but then there's like an inch of play in each gear. Stock trans clicks into each gear and then there's zero play in the lever. Valve body junk? I really wish...

Hey All" I want to put a trans cooler in front of my radiator. How did you guys run the lines back to the trans? It's pretty crowded in there! thanks for any help Steve

Hey All: I've got a 489 carrier and am experiencing some weirdness. I bought a used A body 8.75 from a pretty well known Mopar vendor. The third member was supposedly a "known good" unit. Needless to say I got the car together and the thing is making all kinds of noise. Whining on...

Hey All: I've got an 8-3/4 third member that needs rebuilt. New bearings, etc. Anyone reputable do this kind of thing? Thanks Steve

Hey All: Does anyone have the torque specs for the brackets at either end of the leaf springs and the shackle nuts? I'm putting this back together and don't want to go crazy. I actually bought a manual on CD-ROM for this purpose, but file is corrupt. Dontcha love that? LOL! Steve

Hey All: Got my Moser axles. there were no directions included, so I was curious if I was supposed to lube the bearings at the axle ends? Thanks Steve

Hey All I've got a 318/904/7.25 Dart. I'm replacing the rear with an A body 8-3/4. Stock driveshaft is too long with the new rear end. Also, how do I know which u joint the 8.75 takes? Rear end has a 489 case if that makes a difference. Thanks! Steve

Hey All: Cal-Tracs doesn't include U-bolts with their bars. :angry7: What size do I need when I swap in my 8-3/4 rear? Probably easy enough to figure out, but I don't want to buy them twice. Thanks Steve

Hey: I'm not really happy about my options for adding a shifter to my bench seat car (though I'd appreciate any ideas), but was wondering if anyone had tips for sticking with the column shifter with a performance transmission. Thanks! Steve

Hey All Just got my 8-3/4 rear end for the Dart. It does not currently have axles. I want to upgrade to the BBP when I put new axles in. I have some B body brakes to put on already. I'm looking for something stronger than stock for high 11 low 12 second racing, but I want to stay with the...

Hey All: Going to look at a couple of Darts (70-71) tomorrow. Whats the best way to tell the difference between the 8-3/4 and 8-1/4 rear ends? Thanks! Steve