Search results for query: *

The 4wd in my 06 ram has been buggered for a while. I replaced the tcase motor and it worked for a storm or two. Then it said it was in 4auto, but it never engaged, and i couldn't switch it to any other gear. So today i pulled the tcase motor off and seen that the plug was severely corroded. I...

I have been having nothing but trouble with the 4WD on my 06 Ram 1500 Sport. When I first bought the truck, the "service 4wd" would flash on when it rained, so I pulled the transfer case motor off and found it cracked and full of water. I replaced it, and it seemed to work good for a few weeks...

I got the car running today for the first time in about 3 years, backed it out of the garage, put it in 1st and nothing....second and third seem to be there but no first. The tranny is freshly rebuilt, reverse manual valve body. The fella that built it is top notch and I have 100% faith it was...

What year did they stop using the 3 prong NSS? I have to order one and may be able to get one here at home if they used them in later model cars (80's). If not, it will have to come from the states and take a little longer. Thanks

My car was originally a 3spd manual on the column, and i have since put a 727 in and floor shifter, but now I can't get the key out of the ignition. First, I can't remember where reverse was on the column, and second, is there anyway to remove the lockout so I can still use the column?

About 2 years ago I put an 8 3/4 in my demon with a 741 center i believe. The axles wouldn't slide all the way in so I pulled it out and took a little steel cylinder (slider) out of he chunk, and all was well. Now it is finally time to put a driveshaft in and I want to set the backlash and...

Does anyone know where to find the info that big block dart used to have on 8.75 rears and driveshaft length? Their website has changed and the tech page is empty.

I read a thread with the same problem, but mine doesn't seem to want to fix itself so easily. I have a 8 3/4 suregrip, and I can't get both axles in. I can get one or the other in no problem, but not both. I can actually put one in and not bolt it on, then go to the other side and put the...

What should the length of one of the actual axles be to fit an A Body 8 3/4? I've looked at numourous charts, but couldn't find where i actually take the measurements from. I have a b body housing (thanks Jack, i'm still looking for fittings) and what i was told were A Body axles, but i read a...

Hi, I bought a 8 3/4 3:23 sure grip from a fella a couple of months ago. Before I went to pick it up(about a 2 hour drive) I thought it was an entire rear end, but it was only the center section. He had a housing that I later found out was a B body 8 3/4. I've heard that you can work these to...