1966/'69 A100 Twins Build

-
Based on help from Mark Cameron and Alan Shrock I have my rear doghouse restored to close to what I believe it was from the factory. Only thing is I don’t have a hole where the screw drivers are pointing for another wire clip. I may have filled it when fixing some rust on this one. This is the QuietRide insulation package.


IMG_7807.jpeg
IMG_7808.jpeg
IMG_7809.jpeg
IMG_7810.jpeg
IMG_7811.jpeg
 
Engine harness done, main harness done, backup/neutral safety harness need the 3 prong connector at the transmission to finish. Also mocked up some of the ideas for the engine controls and accessories so I can get hardware ordered to attach it correctly.


IMG_7822.jpeg
IMG_7823.jpeg
IMG_7824.jpeg
IMG_7825.jpeg
IMG_7826.jpeg
IMG_7827.jpeg
IMG_7828.jpeg
 
Jim, To get the alternator mounting brackets on the right bolts, make sure that there aren't any bolts that go through any water jackets if those bolts will have to be loosened and tightened occasionally to adjust the fan belt.
 
You must log in or register to reply here.
-

Back
Top