Someone wasn’t paying attention
1966/'69 A100 Twins Build
- Thread starter Jim Kueneman
- Start date
-
It just not for me and was offered more than I likely ever will again.
mygasser
Well-Known Member
are you going to start on the other twin next jim?
neil.
neil.
mygasser
Well-Known Member
must've missed that, that or getting too old to remember lol.
neil.
mygasser
Well-Known Member
that's right, i remember now you say that.The shop that did the exhaust bought the other one!
Well that wasn’t what I wanted to do. The oldest hit a rock washed in the road during a rain storm and used up the one claim every 3 years freebee no effect on rates earlier this year. Youngster rear ended a truck a month after we got that back from the shop. This one was just cosmetic so I handled it. Don’t have children.
Jim the kids just want you to keep busy messing with car stuff .
@Jim Kueneman , hope all is well. can you give me a pic or explanation of what you did for your heater return line? The magnum is a bit tricky with only one 3/8 port and the others being 1/8. Thanks!
Hey Johnny,
I’m not sure what you are asking. The one was from the water pump and the other I used a big block nipple in the manifold. They were the correct size for the heater core.
Jim
Correct, which fitting did you use to go back into the manifold from the Heater core? I assume the 3/8, being the 1/4 is pretty small, but which did you put the temp sender? Thanks buddy.
The temp sensor went in the 5/16 hole
No kidding, from the drawing I thought that would have been straight thread, and wouldn't have thought a sender or fitting would go. Thanks buddy.
-
