RGAZ
Diehard
From the forum search I found the following:
Raise front of vehicle with engine off.
Turn wheel all the way left. (engine off)
Top off pump.
Slowly turn wheel stop to stop about 20-40 times. (engine off)
Check fluid level. (engine off)
Done.
Start engine.
So I have now conducted this procedure twice and I still get the same result (steering turns left itself at startup).
So is there another way or am I missing something.
FYI - Air got into the box because I replaced a seal on the input shaft that was leaking. I only removed the input shaft section to change that one seal.
Thanks,
RGAZ
Raise front of vehicle with engine off.
Turn wheel all the way left. (engine off)
Top off pump.
Slowly turn wheel stop to stop about 20-40 times. (engine off)
Check fluid level. (engine off)
Done.
Start engine.
So I have now conducted this procedure twice and I still get the same result (steering turns left itself at startup).
So is there another way or am I missing something.
FYI - Air got into the box because I replaced a seal on the input shaft that was leaking. I only removed the input shaft section to change that one seal.
Thanks,
RGAZ