Bolt access hole in axle

[72ScampTramp]

My axles are aftermarket but they dont have the hole in them to line up with the backing plate nuts. Would drilling one be an option here? Can barely get a wrench on them and not enough room for socket and properly torque them.

 

[TrailBeast]

That should be fine since most hubs have them already.

 

[RustyRatRod]

I sure as heck wouldn't want to do it with a hand drill.

 

[younggun2.0]

problem solved

 

[67Dart273]

Some things to think about

Not knowing what you have for bits, you could just drill a "small" hole to clear an extension, and put the socket on after

You can drill some impressive holes with a hole saw, but you need a SLOW speed (I do NOT mean a typical 3/8 drill!!) and LOTS of cutting oil

I once drilled some 2" holes in 1/2" plate on a "the slowest speed" press

Yes, took awhile. I used WD 40, drilled 4 holes, and I think I used more than one can.

 

[Supershafts]

May want to visit your local machine shop

 

[younggun2.0]

or get a wrench like the one in the picture. they are only a few bucks and you dont have to drill or cut anything.

 

[1968dartman]

or get a wrench like the one in the picture. They are only a few bucks and you dont have to drill or cut anything.

x2!!

 

[godfatherofchry]

easy fix with a drill press.........Artie

 

[moper]

Or an internal type wratchet wrench...