Bostonian 71 demon

[B.R.E.Demon]

Last night did a bit of quarter prep and fit the upper window trim to make sure it covered the added holes and it will work out perfectly now I'm debating on running drip rail trim like Carltons car... or none, they didn't seem to start shaving them till 73 so just a thought.

 

[Newbomb Turk]

Valve covers look great, and I agree with you on the vht wrinkle finish.
I did a set of stock magnum v/c's with it , turned out great

I should paint my entire engine with black crinkle paint.

 

[MOPARMAGA]

I should paint my entire engine with black crinkle paint.

That would be awesome, inside and out

 

[B.R.E.Demon]

Didn't do much on the car last night but here's some work on the car. The rear cross bar/ wheelie bar mount came out great, Instead went ahead and bought a new horse for the wife. Tonight will be a lot more progress.

 

[abdywgn]

Didn't do much on the car last night but here's some work on the car. The rear cross bar/ wheelie bar mount came out great, Instead went ahead and bought a new horse for the wife. Tonight will be a lot more progress.

View attachment 1716384829

View attachment 1716384830

View attachment 1716384831

View attachment 1716384832

for every new car project you get, does she get another horse? just asking, wife mentioned that about me and her getting cats

 

[dusterbing the peace]

Didn't do much on the car last night but here's some work on the car. The rear cross bar/ wheelie bar mount came out great, Instead went ahead and bought a new horse for the wife. Tonight will be a lot more progress.

View attachment 1716384829

View attachment 1716384830

View attachment 1716384831

View attachment 1716384832

When she watches you build a race car and says “I want something with horsepower too”…you give her the horsepower

 

[B.R.E.Demon]

for every new car project you get, does she get another horse? just asking, wife mentioned that about me and her getting cats

she wishes

 

[B.R.E.Demon]

Last night after work, we got out to the shop and got the quarter panel hung and about 50% fitted. We ran out of time, but after work today we’ll knock out the rest and finally wrap up the sheet metal replacement.

Also, I’m gonna stir the pot a bit—I’m looking for someone who can do acid dipping or chemical milling, preferably on the west side of the Mississippi. I’d rather not send my doors all the way back to Pennsylvania. I’m planning to send out the doors, some small trim panels, and a few miscellaneous parts to get dipped for weight reduction, so if anyone has good leads or firsthand experience, I’d really appreciate the insight."

 

[B.R.E.Demon]

Had a late night in the shop yesterday, but I got the quarter panel about 98% finished — even filled in the gas filler hole. Once I smooth out AMD’s rough stamp work, I’ll move on to wrapping up the trunk channel and welding out the cage.