64 SRT8 Dart
Well-Known Member
Finally got the pan rails made. Pics soon
Build My Own Aluminum SB Oil Pan
- Thread starter 64 SRT8 Dart
- Start date
-
64 SRT8 Dart
Well-Known Member
Pics.
64 SRT8 Dart
Well-Known Member
Finally got this thing built and it's on the motor and in the car!
MileHighDart
Well-Known Member
Very impressive man ! Nice work.
BrokenTool
Well-Known Member
That is some great craftsmanship, got any pics of it installed on the engine and in the car?
64 SRT8 Dart
Well-Known Member
I can take some pics of it in the car. We were in a hurry to get it in as it's a daily driver so no pics were taken.
I ended up having to modify the k member a little bit as the pass side was rubbing it. The engine sat down all the way but was sitting too far on the drive side.
Marked where it rubbed, took a 2" sched40 piece of pipe, traced half the pipe on the spot, cut it, cut the pipe in half, welded it in. Took about 30 min, lol.
So far no leaks either, lol. Thank goodness, haha.
I ended up having to modify the k member a little bit as the pass side was rubbing it. The engine sat down all the way but was sitting too far on the drive side.
Marked where it rubbed, took a 2" sched40 piece of pipe, traced half the pipe on the spot, cut it, cut the pipe in half, welded it in. Took about 30 min, lol.
So far no leaks either, lol. Thank goodness, haha.
BigWhip
New to Mopar land
You have done a great job.
Thanks for showing all of your work.
Thanks for showing all of your work.
-
