Hard To Find Items Wanted. List Yours

[65dartcharger]

I'm looking for a set of 7.00x13 Goodyear Power Cushions blackwalls and 3 7.00 x 13 white walls. They need to be NOS or mint.

Also looking for the valve located two inch above the intake on 273x4bbl engine. This valve is for protecting oil fumes into the brake booster. It's maid of white plastic with the Bendic name on it. Need to be NOS or mint.

 

[Oklacarcollecto]

Decent trim rings for 1969 or 1971 A body ralley wheels. SBP small dome wheel center.
One or more of either one.

 

[Mister Twister]

A wife that can color sand...

After years of looking I got the wife that can sand.

I want the inside door emblems.

 

[6pk2goDemon]

After years of looking I got the wife that can sand.

I want the inside door emblems.

There are some inside door emblems in the auctions currently going for a member here on FABO.

http://www.forabodiesonly.com/mopar/showthread.php?t=73176

 

[Mister Twister]

Thank you very much for the info. I'll keep an eye on the auction.

 

[6pk2goDemon]

Thank you very much for the info. I'll keep an eye on the auction.

Glad to help. Bid away........:-D

 

[d5667]

I'm lookin for a black split bench with a fold down arm rest. Also lookin for a black trunk tailight cover that goes on the inside of the trunk for a 75 Scamp. They came on brougham Scamps and SE darts.

Have three different full seats,fold down center.69 barracuda no headrests,69 barracuda fold down with head rests 71 dart fold down with headrests black.also have 67 cuda fold down with headrests white 68 cuda fold down no headrests

 

[4spdragtop]

I have been searching for about 2 years now for 69 barracuda b/u tail lights. I have only seen one on ebay and in worse shape than mine.

 

[48limo]

I am looking for the 2 small chrome 'CUSTOM' emblems in good shape for my 70 Dart Custom, I can't seem to find any pics of it though. I do have the emblems but the chrome is quite badly pitted.

i have about 10 of those with new retainers

 

[stan marshall]

I need the plymouth letters that go on the front of my 67 fastback.
Stan

 

[lotsodarts]

Guys i'm just about finished with a 5 yr total restoration on my 63 Dart GT. I am in need of just a few items that I can't find. first and most importantly I need tha "Dodge GT" emblem across the deck lid, the "GT" emblem on the hood and the carpet holdown trim on the inside of the rockers, (not the short ones under the door but the long ones on the inside of the car. Would like NOS or mint used. Thanks.

 

[MoparLvr]

69 Swinger split bench seat.

 

[rmchrgr]

Non lockup 999 trans.

 

[1BadDodge71]

Im having problems finding any part for my Duster :angry7:Its easy to find Chevy and Ford parts,but old Mopar parts are so freakin hard to find here.I would like to find a SBP 8 3/4 rear for my car thats not going to cost me over $500,a nice SBP disk brake set up for my Duster,and 727 TF kickdown linkage(I know I can use the Lokar)and a V8 radiator.

 

[d5667]

Ok bad dodge this really isnt a chevy or ford forum but since you are ranting 69 SS camaro-66 mustang fastback more of them now than built in 66 or 69.All you have to do is open a book and drag out your master card.I know this because i have a 65 and a 66 fastback.I needed a set of grills for my 69 cuda,found a car in San Louis Obispo,flew out and drove it back.Should I sell the rear axle to you for your price?I dont think so.Im sure they are out there somewhere and the owner may not have much in it.But dont act like they are holding a gun to your head.Understand that you are not looking for easy to find parts and if you find them cheap thats great.Enjoy the hobby for what it is.Lots of good people and some not so great.But im looking for a big block A body radiator and shroud and i would like to pay salvage price too.

 

[67valiant 100]

Passenger side quarter for 1967-1969 Valiant 2 door post. That's like asking for the impossiable to happen.

 

[QuitYerBichn]

Got a complete front axle, both springs, drag link, brakes (newly rebuilt), basically a complete front end off a 69 A108. Am in VA

Looking for a driver's side front frame rail if you've got one.

 

[MILO]

63 64 Dart headlamp bezels that are not dented

 

[72ScampTramp]

Used SS or HD leaf springs?

 

[efriedrich]

I have a pair. I could post some pics in a week or so. They are in storeage and I won't be over there until then. I was looking at them a month or so ago and was suprised by there good condition. One is cracked but they are complete.

 

[hendrik]

hi
I am looking for aset of good lokn grilles for my 69 barracuda.
repro is ok to.
can someone help me out?

 

[Dusterdude72]

A nice set of 69 valiant turn signal lens's for the grille

CD player

Glove box liner for a duster that is not junk

tail light panel for a 72 duster but a 70-71 is not out of the question

lower quarter patch panels for a duster

the list goes on LOL

 

[moparclown]

Not an a-body but I am searching for the grille trim for my project car a 71 Cuda.
all stainless grille trim(dented,dinged,twisted are ok)
and cheese graters #1,3 and 6
I want used stuff and not show quality,I will drive the wheels off of this car so the NOS stuff can go on some show poodle.

 

[gts4fuji]

4bbl Intake for a 318 poly Block or a dual quad set up with carbs for a 318 poly block

 

[kt340sport]

Looking for a nice set of tail light bezels , or a set of n o s , or reproduction , any body has a set or knows of a nice unpitted , let me know thanks alot.