Slantsix64
Well-Known Member
Fel pro makes a steel gasket that the heat crossover section has a really tiny hole, I used that on my 318 runs great!
Fel pro makes a steel gasket that the heat crossover section has a really tiny hole, I used that on my 318 runs great!
LOL...forgot to mention I usually REMOVE intake manifolds with heat crossovers in them, and if I, stuck with it, I use a paper gasket with the steel shim to block it off.
Trying to get this done without machine work if at all possible.
May have to start looking for a coffee can.
Do you happen to know the part number of the gasket?
Thanks
You know you can't use a steel shim gasket with aluminum intake, It will always leak.
At some point sooner than later you will have a major mess on your hands.
I knew I had a copy somewhere of the 6 pack intake gasket bulletin.
View attachment 1715567358
I should have mentioned it’s a small block. I wish the owner would have used paper gaskets but he didn’t. So I’m kinda married to the steel shim gaskets. Otherwise I have to mill the intake to fit and I don’t want to reinvent the wheel to put on a heat shield.