Intake bolt

[remytherat]

I have heard that sbm intakes can be swapped without pulling the distributor, but I cant figure out how to get the bolt loose in the back drivers side corner. I have a 9/16 dizzy wrench on it but can’t get any leverage. How is this usually done?

 

[toolmanmike]

I have heard that sbm intakes can be swapped without pulling the distributor, but I cant figure out how to get the bolt loose in the back drivers side corner. I have a 9/16 dizzy wrench on it but can’t get any leverage. How is this usually done?

You can't get it with the box end of a combination wrench?

 

[Professor Fate]

^^ This. Put a box end wrench on it and smack it with the palm of your hand. It's only 35 ft. lbs. You'll probably have to do that with the center bolts, too.

 

[toolmanmike]

^^ This. Put a box end wrench on it and smack it with the palm of your hand. It's only 35 ft. lbs. You'll probably have to do that with the center bolts, too.

I don't think the guy owns a combination wrench.

 

[remytherat]

That bolt holds the throttle bracket on my engine, which blocked the angle to get a wrench on it. Ended up pulling the dizzy which took 30 seconds