It's from my 67 barracuda. It was running like that. Probably just leave it. Just curious.
Is This Big Honking Dent Suppose To Be There?
- Thread starter Bodyperson
- Start date
-
AJ/FormS
68 Formua-S fastback clone 367/A833/GVod/3.55s
- Joined
- Jan 19, 2014
- Messages
- 25,866
- Reaction score
- 13,175
ouch
Doesn't look like a factory "dent". Maybe a little heat & carefully hammer & dollying it out since you have it off?
Probably just a pucker from the draw operation in the stamping .
I have a 394 pan that doesn’t have it ,,,but it’s in the same vicinity of the corner radius.
But my pan is from a later year,,,68 I think,,,,and they might have corrected the die by then .
Tommy
I have a 394 pan that doesn’t have it ,,,but it’s in the same vicinity of the corner radius.
But my pan is from a later year,,,68 I think,,,,and they might have corrected the die by then .
Tommy
Newbomb Turk
Well-Known Member
Send it. It’s not in a place that matters
Knowing a little about forming metal I have to agree with desoto. It just doesn't look like a dent.
It's just a minor flaw from the stamping process, drive it like you stole it!
Looks like a factory defect.....pretty insignificant, I'd say.
If the sukka don't leak...don't **** with it
My opinion
If the sukka don't leak...don't **** with it
My opinion
Looks like the dimple I had to put in my Milodon pan to clear the K-Member in the Max!
famous bob
mopar misfit
clutch or trans explosion ...
Swinger 340
Well-Known Member
It's a 70-72, 318 or 340 oil pan to fit all the Mopars, A,B,C and E bodies. I have several of them and none of them have that dent. Being in the front, I would think something on the road hit it.
Yup, it's a 340.
-
