** NEW ** Trick Flow LA cylinder heads introduced at SEMA

-
Striaght side?

I have no knowledge of this stuff.
 
MOPAROFFICIAL said:
You still line up the bore with the straight side even when it's too large, so the diff is only a few.
Click to expand...

I have never done this, but i have tried different bore sizes with vary little difference........unless it was to small, then the bores, having valve reliefs made a big difference.

Read a thread on another Forum about how those CNC shocker heads can be 20 CFM shy of what's advertised =285 cfm -20=265cfm
Which should not be a surprise, variance that is in reproducing that or should I say duplicating that same CNC on different ports that shifted differently

I think that hits it right on the head!!!! :D
 
You must log in or register to reply here.
-

Back
Top