cwkerr007
Well-Known Member
my magnum eq heads have comp studs and guides and when the rocker is in the correct geometry to measure for my pushrods I don't have many threads on the stud to use should I shim the studs has anyone had this issue????
shim the rocker studs????
- Thread starter cwkerr007
- Start date
-
Can you post some pics of how you have it set up? Also, which rockers are you running?
cwkerr007
Well-Known Member
Well I have taken them off and put the oem on it I started this thread cause the only way I could see to correct the geometry would be if the stud was raised higher cause the geometry would be correct if stud were longer. In other words I was asking if anyone had done this before with success???
If you had to raise them that high, something is out of whack. Could be the brand of rockers. That said, the stock rockers are pretty darn good.
cwkerr007
Well-Known Member
yeah your right and with a 512 lift cam i'm wasting time cause it has been 5 yrs building this with a disability ssi income so I'm starting to feel my foot tapping telling me hurry up before your to old to enjoy it. lol
cwkerr007
Well-Known Member
And since PIE sent those rockers there is no telling what they were for other than to pawn off shelf stock
cwkerr007
Well-Known Member
Thanx for the reply and the help ! Very grateful.
No problem! I've heard both bad and good about PIE. No telling what they sent you, but I would assume a SBC rocker.
Call Mike at B3 Racing Engines. Valve train geometry is his specialty.
www.b3racingengines.com
B3 Racing Engines LLC - Performance Engine Building and Mopar Valvetrains
-
