Thanks.
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
I better get my Demon reappraised!
I bet you will get offers at the show!
I hate to see those prices go up so high (as a buyer) but as a owner and possible seller, it's good to see.
Dryer handle broke off... replacement part $40
Super Glue?Dryer handle broke off... replacement part $40
Pretty high stress point.... don't think it would hold for more than a single pull
Unconventional
Well-Known Member
It's Thirtyfour Thursday!
Good morning
Good morning
Unconventional
Well-Known Member
After that Atlas V launch this morning I looked at the launch schedule for Vandenberg SFB. There was a Delta IV scheduled for this fall from my old stomping grounds at SLC 6. I missed the launch 
it was near the end of September. After more research I found that Delta was the LAST launch for SLC 6 in the foreseeable future United Launch Alliance has a new heavy lift vehicle and they're goin' to Cape Kennedy with it
it was near the end of September. After more research I found that Delta was the LAST launch for SLC 6 in the foreseeable future United Launch Alliance has a new heavy lift vehicle and they're goin' to Cape Kennedy with it 
Would be fun to watch up somewhat close, just far enough back not to be fried. lolAfter that Atlas V launch this morning I looked at the launch schedule for Vandenberg SFB. There was a Delta IV scheduled for this fall from my old stomping grounds at SLC 6. I missed the launch
I was looking at one the other day. I may just try it. I have the 2” version and use it for cleaning up welds.
Almost done rocker. Then clean it up and slather it with rust paint
Just Ron
Active Member
Pretty lucky your dad bought that way back then. It was worth it then, BUT much more now.
And good thing he didn't want it back once I found it.
I did.
Of course, the wife sitting off to the side reading a book piped up "Not for sale" before the guy finished his offer.
He continued and without a glance (still reading her book) she replies louder "what don't you understand it's not for sale...ok then I said guess it's not for sale.
I told her it didn't hurt to listen.
Last edited:
She likes that car. I have started listening lately. Stupid money may buy the car!I did.
Of course, the wife sitting off to the side reading a book would pipe up "Not for sale" before the guy finished his offer.
He continued and without a glance (still reading her book) she replies louder "what don't you understand it's not for sale...ok then I said guess it's not for sale.
I told her it didn't hurt to listen.
She told me recently we can sell the Barracuda when I want but the 55 stays...
Oh, it isn't for sale. Even stupid money, but I will listen to stupid money talking. Unless it paid my house off....then I could start considering it
Last edited:
dukeboy440
Well-Known Member
I need that
Seam seal done, and a coat of fiberglass filler with extra resin added. Grind,fill, prime.
If an electrician's kids misbehave, do they get grounded???
Snowing and cold to
day with a blizzard warning.
Yuck! can't like that Fred
446 mile round trip... 14 miles from the house ... F'n scraggly doe suicides the truck... locked it up so only 35 or 45 mph on impact. Mostly plastic damage that popped out. Might have broken off a clip inside by the fog light.
Went back to check the deer and it was standing on the side of the road... couldn't get a shot at it to put it down before it hobbled into the woods.
Went back to check the deer and it was standing on the side of the road... couldn't get a shot at it to put it down before it hobbled into the woods.
-
