Good Morning All!
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
I guess he is apupted?
Cats, pups, aliens, what the hell's going on here lol!
Don't forget the Lincoln Mark V ghetto-glider
Not sure what that means but the best news is that for the first time since what happened happened to my son, he slept without the lights fully left on. Pup also follows him to the car when we take my son to school and greeted him at the door last night. I’m amazed at how fast they’ve connected
Saw that, thanks! At first glance thought it was a "Christine", need more coffee : )
Sounds like he's got a good loyal friend
Great for him Chris. Was a play on word of the day is Abducted so he is a PUP ted!
Un- separate -able I bet.. congratulations again
Picked up these at HF yesterday and finished hyd filter change, that filter squeaked like an over torqued bolt, bout pulled a muscle spinning it off (no Karl). Was kinda bummed that the stock filter didn't have a magnet like the replacement and my tractors original, hoping no metal was circulating around during the break in.
Morning all.
Glad you got it off. I usually tape a few magnets on the first run filters. Which tool worked for you?
Pretty gal ya got there Mike.
Yep looks like I'm doing glass work most of the day Chris.
You're pretty good at that.
Morning!
cool but clear i think. Going to be a nice day.
Got rear rotors and pads done on the gmc,two wheel bearings today,and one rotor, pads. Job is going to be near $1000 in parts.
Would have finished it yesterday, but stuff happens.
cool but clear i think. Going to be a nice day.
Got rear rotors and pads done on the gmc,two wheel bearings today,and one rotor, pads. Job is going to be near $1000 in parts.
Would have finished it yesterday, but stuff happens.
Good enough I guess. Replacing a back glass in a pick up with an auto slide vent so takes a bit longer to replace and no fun.
No fun is no fun...
I'm taking a mulligan today and spending a little time in the garage
Looks like the same weather here Frank and will take as many as I can get.
Nothing better than hanging out in the garage.
I used the jaw pliers, wasn't sure the three tab would contact all the way around. I'll likely use that three tab/jaw first on the next go around, thanks again for telling me about it (OMR and Frank as well)
Last edited:
Morning !
Oh you know it, she has been cutting my hair(what there is of it) for at least 10 years, I have known her husband for 35 plus years, she gives the best hugs, shake rattle and roll just to mess with her husband
but fun young folks that are now empty nesters, I took that picture of her out back in the parking lot she works at, she loves it and the idea that I gave her back then, it was set up to be a I have fallen and can someone help me up 
it went over great -
