Stop in for a cup of coffee

-
Working with a few different companies. Samples went out yesterday. I have to get 10 each to basically break even. But I needed some so what do you do?
 
I didn't realize you did that many distributers to justify that kind of investment
 
Morning everyone. Stayed up all night surfing a red wave.

Pass the espresso
 
Yes $1200 worth! :wtf: Springs should be here this week.
Hey, do you have stuff for the 72-93 D/w series trucks? Been over there on a couple forums and lots of people looking for ignition parts. Gonna start sending them your way
 
Morning!
Frost again.
And a day of temp barely above freezing.
So i went on the RA website, and ordered my front end parts. Cheaper than amazon with shipping. $105 from amazon,$40 from the rock auto.
And in my trunk were 2 calipers that look to be in very good shape and a set of pads that look hardly used. Going to check the calipers next round. If any of you have seen air being used to get boot started on piston, it really works.
 
Morning!
Frost again.
And a day of temp barely above freezing.
So i went on the RA website, and ordered my front end parts. Cheaper than amazon with shipping. $105 from amazon,$40 from the rock auto.
And in my trunk were 2 calipers that look to be in very good shape and a set of pads that look hardly used. Going to check the calipers next round. If any of you have seen air being used to get boot started on piston, it really works.
I'll have to look that one up. Time to git for me, have a Great Day All!
 
Almost 80 today... They nudged it down a few degrees, but the rain is staying to the West

Sunshine and 55° F already

Screenshot_20241106-082642_Chrome.png
 
OK, soooo this is cool just because I never knew that there was such a thing. Needs a motor though. Mid-engine, how much of a PITA would that be? If this was a VW Vanagon in the same condition it would have another zero on the price.

$3,000


1730900094865.png
 
-
Back
Top