Ever thought about fabricating one or having one cast using custom molds?
Yes me and 805moparkid talked briefly about it.
Ever thought about fabricating one or having one cast using custom molds?
It's definitely something to think about these days.
The pickins are slim around here since the price of scrap hit the ceiling. It took two days of driving from wrecker to wrecker before I finally found a /6 behind a Federated. Bought the whole engine for $50 just so I could have the coveted 1BBL Holley.
I think I'm going to modify a stock one to accept a sideways 2BBL.
That'd be pretty slick. Going to have to figure something out because the cockeyed monsters are outlasting the available carbs ;)
Between here and SS.org I bet a robust solution could be achieved.
I'm more of a hands-on type of guy so I'm always looking to do things the hard way ;)
I like my manuals in the tree
Yeah Slant6.org is where I have been reading up on a lot of stuff including how to mate a T5 from a 4 or 6 cylinder Mustang but the bad part is a rear gear change will have to be done. Can you think how much fun that /6 will be with EFI and 5 speed?
A mustang trans will bolt up to a /6?! You have my undevided attention!
ok bro u have to look at what u got do u want to have 4 k in that when ur done and it still looks like it do lol .. lets get that thing running then bring that thing over so we can fix the rust and we can paint her if ur going to put a trans in her i would get the newer 904 that we have to go in herA mustang trans will bolt up to a /6?! You have my undevided attention!
Dang. I was hoping it would just bolt right up without adapters. : (
Yes I have, but it was back in 74. It was a 73 dart sport w/ 2bbl carb.Interesting! Have you done this before?