Transgo TF-2 Instructions

[swifty]

I am rebuilding by 727 which had an existing shift kit.

Time for 727 rebuild.

I think it is a TF-2, was done before I owned car. The line pressure spring is blue. There is a wall drilled out in a pocket, check ball removed and plug in case. Does anyone have a set of instructions they can send me? I had another member send me some, but unfortunately I can not read them.

 

[DentalDart]

I'll post them in the thread here in a second, I just have to take the pictures if the pages.

 

[DentalDart]

Or would you like them posted in your rebuild thread?

 

[swifty]

This one is fine.

 

[DentalDart]

Here you go!

 

[swifty]

Thanks a lot! Hope to figure out what I have. It worked pretty well pre-teardown but want to check it over before it goes back together.

 

[mopowers]

Keep in mind the instructions have changed slightly over time.

 

[swifty]

Keep in mind the instructions have changed slightly over time.

I know the earlier TF-2 used different springs on PR valve. Does the B&M kit use a blue spring on the PR valve? Mine has a single spring with no shims. I will check the length of TV valve to see if it has been ground. I will also check spring.

As I said it worked ok pre-teardown but had some issues when opened up. If it was as stock trans it would be easy to figure out.