In their early A body? Looking at adding one to my 66.
What do you hope to gain?
Nope, stock fan.I need to check and post a picture. I know I fought with one on my 70 Swinger as far as clearance.
What is wrong with your current setup?Well, just exploring different options.
Should not need to if the cooling system is functioning correctlyI am going to have the rad converted to 3 core.
Running a 180 Stat so as far as out current temps go it’s been averaging 105.
With 105 deg outside air temp that is normalTemp gauge runs in the 200 area bot in town and freeway driving.
The thermostat only sets the low temp, the cooling system, outside air temp,air flow and load on the engine dictate the running temp.I may put a high flow 160 degree stat on to see if it lowers the temps
Do you have a fan shroud on it?
Look at that... A 4 blade fan that cools a SB ( I assume just fine), and without a shroud.Nope, stock fan
200 is nowhere near a problem!!!!!! if it stays around there RUN ITWell, just exploring different options. I am going to have the rad converted to 3 core. Running a 180 Stat so as far as out current temps go it’s been averaging 105. Temp gauge runs in the 200 area bot in town and freeway driving. I may put a high flow 160 degree stat on to see if it lowers the temps
LOL....A Dumb Thumb, and lack of proofreading! Fixed it. Thank You making me aware of that