You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
Hey Folks,
Thought I'd share the following showing our low-buck fix for damaged taillight housings and missing mounting tabs. Being on a tight...
-
Below is the last published speed tips from MP from there 2000 catolog. This should help answer a few questions on what works and what doesn’t...
-
Pulled a Holley electric red pump off the shelf to put back in action, thing is it's been sitting for 12yrs... so it's going to need a go...
-
Really a good chart for factory paint colors
1964 - 1974 Factory Engine Paint Chart
Footnotes:
1: Most 1969 - 71 383 4-bbl engines equipped...
-
This comes up enough that it seemed worthwhile to create its own thread.
Part 1. Chrysler Vacuum Advance Canisters (pods)
Lets start with how two...
-
I have been looking for good trunk torsion springs for my 69 Dart GT convertible. Well to no avail... So I will put struts in the trunk to keep...
-
Been doing this for years the same way. I'm a body/paint guy but anyone can do this.
Small 5 gallon bucket with lid. Cut 9" hole in bottom side of...
-
Hi y'all,
I have a 69 ignition switch with key I bought that was used but out of a low mileage Mopar that was rotted out. That part is a...
-
This was on my '72 Demon's keyless latch. I don't know if it's the same as the keyed latch.
1.-- Remove the two screws holding the latch in place...
-
I recently disassembled my convertible top pump to inspect its condition. I think most people just replace them when they have issues. It turns...
-
Do you have a set of 69 cast reflector bezels, and upon removal snap a cast in stud. That sinking feeling that goes along with what just happened...
-
As a lot of you know I have been rebuilding a lot of distributors lately and by far the largest issue with them is this.
to prevent this is...
-
So you decide like I did to disassemble the dash and paint everything, clean well and then there is the heater and AC control cables. Here is a...
-
Attached below is a scan of the factory instructions for installing the map light (2587074) on early A-Body cars. The wire that goes to the door...
-
Hi,
I would like to show how I made myself a short nose water pump. Having issues with water pump to radiator clearance and not being able to...
-
My 1965 Plymouth Barracuda came with single circuit brakes. Here's how I converted the old girl to dual circuit.
Old single circuit MC.
I...
-
So, I decided to replace the quarter panel on the 66' and when cutting off the outer skin I found the inner wheel well lip gone. Some of the lip...
-
I have no idea what the long term effect of what the heat will have on the vacuum hose, but I did put it right over boiling water for 1/2 hour and...
