Recent content by Mpfd203

You are next in line. I'm going to give the guy ahead of you a few more days to respond.

Hughes Engines is where I purchased the heads

Here is the cam specs I was running in it.

Cleaning out the shop. I have a 440 block with a .030 bore. This block have less than 500 miles on it. The deck height is approx. 10.658. There or a few scratches in some of the cylinders. The deepest is in #3 (see pic). That is the cylinder that dropped the valve. everything has been cleans and...

I have a pair of 60825 Fully CNC cylinder heads with Harlan Sharp 1.5 roller rockers. These heads have less than 500 miles on them. One cylinder seat has been reworked. Intake valve dropped out of it. Everything has been fixed. New valves and guides. Has been pressure checked. One of the rocker...

I'm cleaning out my shop. I have a Weiand RB dual quad tunnel ram with a pair of 450 holleys and air scoop. $450.00 plus shipping. Mount Pleasant, Iowa PM me

On your Fitech FCC, what method of payment would you like? Paypal, personal check, bank check, cash

I am thinking about doing away with my carbs and going with the Fitech 2x4 unit. Is anyone running this setup on their vehicles. I have a 540" BB Mopar with a custom roller cam w/ .570 intake lift, .575 Exhaust lift, duration @ .050" 255 degree intake and 259 degree exhaust. Edelbrock...

Still for sale?

Looking for a pair of decent headlight rings for my 1963 Dart.

Joe, I'm the guy that has the 63 Dart you built. Could I get your email address so we can correspond back and forth about the car? Mine is [email protected] Thanks Drew

Let's set it up. You can count me in!!!

Pic #10

Pic #9

Pic #8