Search results for query: *

Question, Can i use the 1.6" wide band on a regular 4 disc front clutch retainer.

Can't find This assemly number anywhere, it's a 904 Can any one tell me the year and application.

I've always used iron seal rings in my trans builds , because the teflon ones didn't look right to me . But since the trans was in pieces , I did an experiment . With the front clutch mounted on the pump i did an air test of the clutch pack , first with the iron rings , then the teflon . Result...

Any Idea what caused this to happen to my 904.

Pulled apart my recently rebuilt 904 for inspection and found the low reverse band was burning on the inner section only . It is obvious this is due to a faulty band that is not wrapped evenly and is dragging on the drum when not applied . It's not the first one I have purchased like this , I...

Broke a couple of teeth of the crown wheel at the strip @ full throttle in 1st gear , is this likley to do any damage to my freshly built 904 . Reason I ask is , The trans has developed a bad 1st - 2nd shift I would describe it as severe overlap . Has a Cope reverse manual VB . I did a...

This was quite useful to me , so I thought I would share it . It's a stock 6.1 with 1 7/8 " headers , EFI Source megasquirt Gold Box and and WOT timing set at 23 degrees. A while back I requested this from Mike at EFI Source , to help me fill out my convertor spec sheet . I posted it with his...

This ' New Hemi Swaps ' section at FABO has been my number 1 go to place for info and ideas on my project . a BIG THANKS to all the contributors. So now that I have made some progress and have a growing cache of photos , I thought it might be a good time for some "show and tell" , while...

Cracking at the pump drive slots on 904 converters is common . What have people done to help eliminate this.

I've seen a few guys here use the GM type II PS pump , since my engine came without a pump I will be doing the same , but before I go ordering the pump and Chrysler pulley . I notice there are two shaft sizes available on the GM pumps 5/8 and 3/4 . which one is the closest fit to the Chrysler...

Any one here got one of these , Milodon 31003 road race oil pan .

I have done a bit of a search on this , but got some conflicting results. I'm trying to find out if this system comes with some sort of base tune . Here's the item description and part number to avoid confusion . Mopar programmable EMS with loom for 6.1 , P5153921 .

I will be using an ATI super damper on my 6.1 there are three options for this engine . 918432 - 5% OD 918437 - 17% OD 918438 - 13% UD I'm thinking it for a N/A engine it would be the last one 13% under-drive . Any-one used it , comments ? . The engine is going into my Valiant , no P/S...

I think the Next Generation Controller ( NGC ) on our Hemi's use a 36T Crank Trigger Wheel with 2T missing & 2T filled-in . Does anyone know what the configuration of the Camshaft Trigger is .

Hi all , I'm new here , I've got a few questions about a G3 Hemi swap , I,ve had a good read of some of the threads here , i'm starting to get a good idea of whats involved in with the mechanical side of an A-Body swap , the whole engine management part i'm having trouble understanding . First...

Any one here know what is involved to change the grille on a 62 lancer to a 61. also are the tail light an easy swap .