Search results for query: *

Yes have to watch for hood to air cleaner clearance.

Also tired of the leaking so broke down and bought a flaming river manual steering box and adapter, much happier now!!:toothy8::toothy8::toothy8::toothy8::toothy8::toothy8::toothy8::toothy8:

Same thing happened to me back in 1978 when the car parts were still fairly new (only about 6 years old). Hit a bump left by the sand sealing truck and ripped the ball joint out of the A-Frame.

Hi Ed As long as your back wheels are in the air and you are not undoing your springs, The rearend will be sitting on your springs and shoud not move when you remove the plates. If you do not have a drive shaft attached, I would support the third member so it cannot spin. Just mount the...

Thanks for the replys - I think the bolt is complete and out but I will check that to make sure. The pin could be rusted in a bit, because when I opened the cover it was full of ice, so it may need some persauding.

Should it slide out either direction or does it come out only one way? The one I am trying to remove is broken so I need to know if it matters which direction the pin goes.

Hi Guys and Gals - 1st time I am tearing down a 8 1/4 rear end and I cant figure out how to pull the centre pin out shown in the picture. I pulled the bolt out that was on the side but can't figure out how the pin comes out. Is it just pushed in or is it threaded in? Thanks Dwayne

Thanks Terry Thats what I did, guess I better pick another tire shop LOL. Dwayne

After rebuilding the front end of my 72 Dart and installing Disk brakes, I took my car to the tire shop to get a wheel alignment and they told me there was no pre-load on the torsion bars!!!!!!!!!!!! I not sure what they are talking about and that is why I am asking the question here. Dwayne

Speaking of torsion bars, can anyone out there tell me how to pre-load the torsion bars when installing them? Thanks Dwayne

I just installed a k-frame on my 72 Swinger, the original manual has the torque for the bolts and I believe it was 150 Ft/lbs as mentioned before is correct. I also have a couple sets of bolts if you need.