Search results for query: *

I would like to know if their is any hood clearance issues from someone who has installed one of the Mopar Magnum Crate 360's with the included Mopar M1 single plane intake. The engine will be installed in a 1968 Dart GTS. Either an Edelbrock or Holley carb will be used. The engine part...

Iwent to look at the engine and the owner had paperwork saying it was part number P5007646 which was listed as a 395 HP version of the 360. I will probably buy it, but I am concerned about hood clearance with the M1 manifold. It will go in a 1968 GTS Dart. Edelbrock only lists their Air Gap...

Thanks for the input so far. I am still interested if someone knows how to ID the version. Would it have anything stamped on it somewhere?

I am going to look at a slightly used Mopar crate 360 with the single plane M1 intake. From looking at their history I see them listed at 380Hp and 390HP. Was their any difference or just a revised rating? The bigger question, is their an ID on the motor to positively identify which version...

Thats understood krazykuda. I am only dealing with the choice between two right side mounts I have, and which one is the correct one.

Thanks for the pictures Oldmanmopar. Lets see if we can use yours for the question. Using the 3d picture ,the bracket in the back on the right hand side without the pad attatched, is laying on its flat surface. If I measure the height from the table to the top of the bracket right across the...

Still hoping for a reply from someone. If the initial thread is confusing I will ask in a different way. When the passenger side bracket without rubber is placed flat side down on a table, what is the height to the top of the bracket? Two inches or 1 3\4. Thanks

I am installing a 340 in 1968 Dart and I have 2 passenger side brackets to choose from. When looking at the side profile one of the brackets measures 1 1\2" from the flat base on the outside of the bracket to the center of the hole and about 2" overall height. The other bracket measures 1...

Thanks for the replies. Nope, no oil leaking from behind the brass plate. Hole must not have been to big. I do know that it had been mildly gone through by a machine shop before me. Note the fresh freeze plugs but the plate had paint on it. Also was it common for late model 340's to have an...

I am installing a 1973 340 motor but would like to know what this plate may be located on the right hand side of the block. Other information: It may not be odd, but the block is cast as a 1970 while the ID stamped below the cylinder head indicates a 1973. It is externally balanced.

I ended up swapping just the water pump and left the timing cover alone so that timing marks are still correct with the damper. This did require swapping the alternator brackets also, but then everything else is left alone. I will be putting a 998 style transmission with lockup and lower 1st...

Thanks for the replies. My question would be- what is the sequence of events to build a new timing mark on the 340 balancer? Would I have the 340 engine rotated to TDC on removal of cover and then make a mark after installation of the 318 cover on the damper?

I am swapping out the 1968 318 in my Dart convertable to a 1973 340 engine. My 1st problem is the brackets for the power steering do not work out for the water pump cover on the 73 340. The second thing is the water hose to the radiator is on the passenger side on the 73 340 and the drivers...