Search results for query: *

boil it then put a little lube on the tube and slide it on. I like liquid graphite.

67 GTX I think will work, not sure.

Best I have at the moment.

Yep use the Mopar adapter. I used it on my FItech but should be the same.

Are you talking about the ones under the exhaust ports? I tapped mine and used 1/4 20 plugs in my 360.

Have it on my Barracuda. Love it, 360, 727.

I used the Holly adaptor.

hour- hour and a half. Couple cans of carb cleaner to clean parts. just lay it out as you take it apart, clean and reverse.

looks like its time for a rebuild kit. Holly's are famous for the gaskets drying up and shrinking. Easy to do, you can do it.

where is the gas running out at.

Stay away from airtech, I had one I put on leak out of the crimp on top.

Any small block pump should work. Did you hold them next to each other?

I am running an in tank pump, tanks inc. setup all fittings are dry.

I will check that out. I have the tanks inc. setup with the in tank pump, all fittings are dry. The car runs great, just that little bit of gas smell if I park in the attached garage.

Any of you guys running this getting a fuel smell in the garage. When I park my car after driving it, if I walk into the garage the next morning I can smell gas. If I come in a couple days later it's gone.

I used the tanks inc tank with there matching fuel pump. It is a warlbro pump.

Get the Mopar engine book. It will tell you where to epoxy the dams for better fuel distribution.

Look in the FItech tuning thread. FITECH EFI TUNING tips, info sharing, ideas, settings, etc...

here's mine, went with the tanks inc. stuff as well. Just follow the directions on the sender, mine works good, it's slower going up. I found it better to set the pump up for depth, then get the sender in before the pump. EFI for the Barracuda

These would be loose on 3 inch.

Anyone have an issue with the clamps for the O2 senser bung. I have 2 1/2 inch exhaust and with the clamps as tight as they could go, I could put two fingers between the clams and the pipe.

For the guys with in tank pumps. Are you running a filter before the TB? If so what are you running? I am going with a tanksinc tank, with pump.

Bowl vent open or closed at idle?

LD340 on mine, and I still use the stock air cleaner.[/IMG]

try this place. http://www.raceone85.com/